Albert Park Stump Removal & Tight Access
Stump grinding 300–400 mm below ground in Albert Park, including tight-access side paths and courtyards. No regrowth, clean finish.
- Free quotes
- Fully qualified & insured
- 16+ years

Stump removal and tight access in Albert Park, done properly
A stump left behind in a Albert Park garden is a trip hazard, a home for termites, a mower obstacle and, given time, a source of suckers. Aps Tree Removal grinds stumps out 300 to 400 mm below the surface — deep enough to plant over, turf or pave — and our narrow-access grinder gets down side paths and into courtyards that bigger machines cannot reach.
The nearest suburbs we also cover are Middle Park (about a kilometre), Southbank (2 km), St Kilda (3 km), so a job in Albert Park is often paired with one next door.
For tight access the sequence is the same with smaller gear: a compact grinder that fits a 750 mm gate, or a mini machine for courtyards. It is slower than the big grinder, but the result is identical — the stump is gone below the surface, not cut flush and left to sprout.
Access decides the machine, not the result. Through a 750 mm gate we bring the compact grinder; into a courtyard, a mini machine; where nothing fits, hand tools. Every route ends with the stump below ground and nothing left to sucker.
Stump Removal & Tight Access in Albert Park — what we do
Stump grinding
Down to 300–400 mm below ground, surface roots chased out.
Tight-access grinding
Compact and mini machines for side paths and courtyards.
Large & multi-stem stumps
Mature hardwoods, palms and cypress rows.
Backfill & tidy finish
Grindings back in or removed and replaced with soil.
A tip from Api
A stump cut flush is not a stump removed: most species in Albert Park gardens will sucker from it, and the roots keep lifting paving. Grinding below the surface is what actually finishes the job.
The full service pages: Stump Removal and Tree & Palm Removal — every one available in Albert Park.
Guides from Api: Tree removal insurance: what home insurance covers when a tree comes down · Tree removal near me: how to find the right crew in Melbourne's west
Do you need a permit to remove a tree in Albert Park?
Albert Park is in the City of Port Phillip area, and that decides whether a permit is needed before a tree comes down.
Port Phillip’s Community Amenity Local Law 2023 requires a significant-tree permit before pruning or removing a tree or palm on private land with a trunk circumference of 150 cm or more measured 1 m from its base — a multi-stemmed tree counts if its exterior stems add up to 150 cm, and so does a stump of that size.
The application takes a site plan, photographs or diagrams of the proposed work and, for a body corporate, the committee’s consent; the council arborist reviews it and the council asks for ten business days. Some pruning is exempt under the local law itself.
This permit is in addition to any planning permit: the council also publishes a clear guide to the state canopy-tree clause, and an online checker for both tests.
Source: City of Port Phillip — trees on private property, 03 9209 6424. Read 13 September 2026; councils change their local laws, so Api checks the current rule when he quotes.
Across Victoria since 15 September 2025
Clause 52.37 Canopy Trees
A canopy tree is a tree more than 5 m tall, with a trunk circumference over 0.5 m at 1.4 m above the ground and a canopy at least 4 m across. In a residential zone a planning permit is needed to remove, destroy or lop one in a residential zone if the lot is vacant, or, where there is an existing house, if any part of the trunk is within 6 m of the narrowest street frontage or 4.5 m of the rear boundary.
Dead trees, emergency and safety works, maintenance pruning and listed weed species are exempt; councils usually condition a permit on planting a replacement canopy tree, and most decide these through VicSmart in about ten business days.
What this means for you: tell Api where the tree sits on the block and he will tell you whether a permit is needed before anything is cut — and where one is, we can prepare the arborist assessment the application needs.
Stump removal jobs by Api and the crew
Real jobs, real photos — Api, the crew and the truck, across Melbourne’s inner bayside. Nothing staged, nothing stock.
Stump removal around Albert Park
The same crew, the same day rates, in the suburbs next door:
Other services in Albert Park
Tree services made easy
At Aps Tree Removal, we simplify the tree and hedge removal experience with a clear, step-by-step approach.
Contact us
Want to learn more? Call 0422 856 090 or send the form and speak with Api.
Get a quote
Getting a quote is quick, easy, and free.
On-site inspection
A quick, thorough site assessment — species, access and risks.
Professional removal
Clean and safe work, chipped and cleaned up — no mess, no hassle.
What clients across Melbourne’s inner bayside say
Albert Park Stump Removal & Tight Access — common questions
Do I need a permit to remove a tree in Albert Park?
Yes, if the trunk is 150 cm around or more measured 1 m from the base (or the exterior stems of a multi-trunk tree add up to that): Port Phillip requires a significant-tree permit, decided by the council arborist in about ten business days, on top of any planning permit. The state canopy-tree clause applies to smaller trees near a boundary. Across Victoria, Clause 52.37 Canopy Trees also applies since 15 September 2025: a planning permit is needed to remove, destroy or lop one in a residential zone if the lot is vacant, or, where there is an existing house, if any part of the trunk is within 6 m of the narrowest street frontage or 4.5 m of the rear boundary. Api checks both at the quote.
How much does stump removal cost in Albert Park?
Priced per stump by its width at ground level and how the grinder reaches it. Ask for stump grinding on the tree quote if a tree is coming out — it is much cheaper on the same visit.
How long does it take?
Quick. The grinding is usually done before the morning is out; larger jobs take half a day.
Can you get in if the access is tight?
Yes — tight access is in the name of the page. The compact grinder needs about 750 mm; where the gap is narrower still, we have a mini machine and hand options.
What happens to the waste?
Backfilled with the chips, mounded slightly to allow for settling, and the lawn swept. If you would rather have soil, we bring it.
How deep do you grind, and can I plant or pave over the spot?
Standard depth is 300–400 mm, which takes the crown and the top of the root plate. Turf can go on the next day; concrete or a deck footing can go in once the grindings are removed and the hole is filled with compacted soil.



